1/4" barva CMOS 170° Wide Angle auto Rearview kamera pro HONDA CRV a Other Sedan HL-5812

Specifications:

• IP Rating: IP66
• TV Lines: 420 TV Lines
• Sensor: 1/4" Color CMOS
• System: NTSC/PAL
• Numbers of Pixels: 580 x 492/628 x 582
• Minimum Illumination: 0.2 LUX
• Lens Angle: 170 degrees
• Operating Temperature: -25°C - +75°C
• Operating Voltage: 12V DC
• Compatible with: HONDA CRV & Other Sedan

Features:

• Mounting lamp of the car rearview camera instead of lighting facilities
• Car rearview camera has distance label
• This car rearview camera is essential because the driver and the rear-view camera are in opposite positions
• Rear-view HONDA camera is also generally mounted at a downward angle
• The vehicle camera enables drivers to see objects and people directly behind their vehicles
• This is a NON-OEM product

Details:

• These cameras enable drivers to see objects and people directly behind their vehicles

• You can install the car rearview camera easily. And the exquisite details of the camera

• With the cord, you can download or uploading the video information in short time

• You can image the size of high quality camera according to the coin

• When you drive your car, with this camera, you will be not miss the wonderful events

How to Install a Rear-View Camera in Your Car:

• Disconnect the battery cables from the battery. Check the vehicle's repair manual to find out what size wrench to use. Leave the disconnected cables a safe distance from the battery posts
• Decide where you want to install the rear-view camera. Most people put them in the plastic bumper so they don't have to drill into the car's sheet metal
• Drill a hole for the camera. Check the installation instructions to see what size drill bit to use. Don't make the hole too large or the camera will fall out
• Place the camera in the hole using the rubber grommet supplied with the camera. Make sure the camera and grommet are tight
• Attach the camera's power wire to the backup-light power wire on your car. You'll have to splice the wires together. Use wire cutters to cut the wires, leaving enough excess wire to reconnect. Strip the ends of the wire to expose the bare wire using wire strippers. Splice the wires together using a two-into-one connector. This will give the rear-view camera power when you put the car in reverse
• Route the camera's output wire to the rear-view monitor and connect the wire to the monitor's input. For installation of the monitor, see the monitor's installation instructions
• Reconnect the battery, start the car and put the car in reverse. The rear-view monitor should turn on and give you a view of what's behind you

Package Included:

• 1 x Car Rear View Camera
• 1 x User Manual
• 1 x Positive - Negative Power Connection Cable